Cylinder Head Disassembly - Taylor-Dunn G0-010-00 Service And Replacement Parts Manual

CYLINDER HEAD DISASSEMBLY

CAUTION
Wear eye protection during cylinder head disassembly
and reassembly or when working with the valve springs.
NOTICE
Keep mated parts together and in order with respect to
their location in the cylinder head for assembly
purposes. It is important to install cylinder head
components back in the same location. Mark each
component or place them in an organized rack as you
remove them.
q
1. Remove the valve tappet
2. Compress the valve spring by hand using valve
spring compressor adapter.
Valve Spring Compressor Adapter
PV-43513-A
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
3. Push down on the spring
from the cylinder head.
4. Slowly release valve spring pressure and remove the
5. Remove the valve retainer
6. Lift up the cylinder head and push the valve
7. Repeat the previous steps to remove the remaining
8. Clean the combustion chamber and head gasket
ENGINE / COOLING SYSTEM
e
q
keepers .
compressor adapter.
w
r
stem seal and valve spring seat
valve seal.
NOTICE
Replace valve seals whenever cylinder head is
disassembled. Hardened, cracked or worn seals will
cause excessive oil consumption.
keeping it in order for reassembly in the same valve
guide.
valve.
surface.
and remove the split
3
e
, valve spring , valve
t
. Discard the
y
out,
3.49