Taylor-Dunn G0-010-00 Service And Replacement Parts Manual page 137

7. Grasp the oil pump shaft and pull it outward to
remove the shaft, oil pump cover
a
pump gerotor . This will prevent the oil pump drive
pin from falling out and into the crankcase.
NOTICE
a
The gerotor set has two orientation dots that must be
installed inward upon assembly
8. Remove the center gerotor, pin and shaft from the oil
pump cover.
NOTICE
There is a spacer in between the inner oil pump gerotor
and the oil pump cover.
9. Remove the oil pump gerotor that is in the engine
case (if needed).
10. Clean the gerotors to remove oil.
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
11. Inspect surfaces of pump cavity in crankcase and
o
and inner oil
surface of pump coverfor scoring or wear
12. Inspect gerotor for scoring or other damage. Replace
parts as a set if damaged.
ENGINE / COOLING SYSTEM
s
.
3
3.77