Taylor-Dunn G0-010-00 Service And Replacement Parts Manual page 70

ENGINE / COOLING SYSTEM
13. Place a shop towel beneath the fuel line quick
connector to catch any fuel. Disconnect the fuel line
e
from the fuel rail by pressing in on the quick
connector tabs.
14. Move fuel line to the left-hand side of the engine
compartment. Make
installation.
15. Remove the spark plug wire from the engine.
16. Remove (+) positive cable
desired, remove the remaining starter motor bolt and
remove the starter motor from the engine.
17. Remove (-) negative cable
mounting nut.
18. Disconnect the upper engine coolant hose, bypass
hose, and ECT harness connector.
19. Remove the two bolts securing the muffler to the
frame. Remove the three hex bolts securing the
exhaust head pipe to the engine. Maneuver the
exhaust assembly out of the mounting grommet and
remove the exhaust assembly as one.
20. Place a support between the main frame and
transmission case. Do not pinch any lines.
3.10
note of line routing
r
from the starter motor. If
t
from the starter
21. Use an overhead or portable engine hoist and
suitable engine straps to secure the engine in its
current position.
22. Remove the four bolts and nuts
engine to the front motor mount bracket.
23. Remove the eight bolts
brackets to the engine and transmission.
24. Loosen the two bolts and nuts
bracket can be slightly tilted away from engine.
for
25. With the help of an assistant and the engine hoist,
raise the engine vertically out of the vehicle frame.
Have an assistant help guide the engine in and out of
the vehicle while using an engine hoist to prevent
personal injury or damage to the vehicle components.
26. Install the engine stand adapter (PU-50824) onto the
engine PTO side mounting ears as shown below.
27. Select the proper engine stand sleeve adapter and
install it onto the engine stand adapter.
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
i
securing the
u
securing the coupler
y
so the engine mount
CAUTION
© Copyright TAYLOR-DUNN