Brake System; Brake Fluid Inspection; Brake Hose And Fitting Inspection; Brake Pad Inspection - Taylor-Dunn G0-010-00 Service And Replacement Parts Manual

BRAKE SYSTEM

BRAKE FLUID INSPECTION

Always check the brake pedal travel and inspect the
brake fluid reservoir level before each operation. If the
fluid level is low, add DOT 4 brake fluid only.
Brake fluid should be changed every two years. The fluid
should also be changed anytime the fluid becomes
contaminated, the fluid level is below the minimum level,
or if the type and brand of the fluid in the reservoir is
unknown.
The brake master cylinder reservoir
through the front left wheel well by opening the hood..
1. Position the vehicle on a level surface.
2. Place the transmission in Park (P) and chock
wheels.
3. View the brake fluid level in the reservoir. The level
should be between the MAX and MIN level lines.
4. If the fluid level is lower than the MIN level line, add
brake fluid until it reaches the MAX level line.
5. Install the reservoir cap and apply the brake pedal
forcefully for a few seconds and check for fluid
leakage around the master cylinder fittings and the
brake caliper fittings.

BRAKE HOSE AND FITTING INSPECTION

Check brake system hoses and fittings for cracks,
deterioration, abrasion, and leaks. Tighten any loose
fittings and replace any worn or damaged parts.

BRAKE PAD INSPECTION

1. Check the brake pads for wear, damage, or
looseness.
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
2. Inspect the brake pad wear surface for excessive
wear.
q
can be accessed
3. If any one pad is less than the service limit then all
pads should be replaced.

BRAKE DISC INSPECTION

1. Check the surface condition of the brake discs.
2. Measure the thickness of the front and rear brake
discs.
3. The disc (s) should be replaced if thickness is less
than the specified service limit
MAINTENANCE
MEASUREMENT
Brake Pad
.030" (0.762 mm)
2
2.31