Rear Pad Installation - Taylor-Dunn G0-010-00 Service And Replacement Parts Manual

REAR PAD INSTALLATION

1. Install new pads in caliper body.
2. Install caliper and torque mounting bolts.
TORQUE
Rear Brake Caliper Mounting Bolts:
46 ft-lbs (62 Nm)
3. Turn adjuster screw back in finger tight using a hex
wrench. Then back off 1/2 turn.
4. Slowly pump the brake pedal until pressure has been
built up. Maintain at least 1/2"(12.7 mm) of brake
fluid in the reservoir to prevent air from entering the
master cylinder.
5. Fill master cylinder to Max level.
6. Burnish brakes as outlined in this chapter.
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
BRAKE SYSTEM
9
9.19