Storage Tips - Taylor-Dunn G0-010-00 Service And Replacement Parts Manual

STORAGE TIPS

Stabilize the Fuel
1. Fill the fuel tank.
2. Add Carbon Clean Fuel Treatment or Fuel Stabilizer.
Follow the instructions on the container for the
recommended amount. Carbon Clean removes water
from fuel systems, stabilizes fuel and removes carbon
deposits from pistons, rings, valves and exhaust
systems.
3. Allow the engine to run for 15-20 minutes to allow the
stabilizer to disperse through the entire fuel delivery
system.
Fog the Engine
1. After stabilizing the fuel, remove the spark plugs and
add 2-3 tablespoons of engine oil. To access the plug
holes, use a section of clear 1/4" hose and a small
plastic squeeze bottle filled with the pre-measured
amount of oil.
2. Reinstall the spark plugs. Torque to specification.
3. Apply dielectric grease to the inside of the spark plug
cap and reinstall the caps onto the plugs.
4. Turn the engine over several times using electric
start. Oil will be forced in and around the piston rings
and ring lands, coating the cylinder with a protective
film of fresh oil.
5. If fuel system additive is not used, the fuel tank, fuel
lines, and injectors should be completely drained of
gasoline.
NOTICE
Starting the engine during the storage period will disturb
the protective film created by fogging and damage
could occur. Never start the engine during the storage
period.
Inspect and Lubricate
Inspect all cables and lubricate all areas of the vehicle as
recommended in the Periodic Maintenance Chart.
Fluid Levels
Inspect the fluid levels. Add or change fluids as
recommended in the Periodic Maintenance Chart.
• Rear gearcase
• Transmission
• Brake fluid (change every two years and any time the
fluid looks dark or contaminated)
• Coolant (test strength/fill)
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
Oil and Filter
Change the oil and filter.
Air Filter/Air Box:
1. Inspect and clean (or replace) the pre-cleaner and air
filter.
2. Clean the air box.
3. Drain the sediment tube.
4. Clean or replace the breather valve.
Battery Storage:
Refer to Electrical Chapter for off season storage
procedures.
Clean the Exterior:
Make any necessary repairs and clean the vehicle as
recommended.
Storage Area/Covers:
Set the tire pressure and safely support the vehicle with
the tires slightly off the ground. Be sure the storage area
is well ventilated. Cover the vehicle with a proper cover.
Do not use plastic or coated materials. They do not allow
enough ventilation to prevent condensation, and may
promote corrosion and oxidation.
MAINTENANCE
2
2.9