Caliper Removal; Rear Caliper Disassembly - Taylor-Dunn G0-010-00 Service And Replacement Parts Manual

CALIPER REMOVAL

1. Safely support the rear of the machine.
WARNING
Use care when supporting vehicle so that it does not tip
or fall. Severe injury may occur if machine tips or falls.
2. Use a wrench to remove the brake line. Place a
container to catch brake fluid draining from brake
lines.
3. After the fluid has drained into the container, remove
the two caliper mounting bolts and remove caliper.
4. Clean disc, caliper body, and pistons with brake
cleaner or alcohol.

REAR CALIPER DISASSEMBLY

1. Remove brake pad adjuster screw
2. Push upper pad retainer pin inward and slip brake
u
pads past edge, if pads are still installed.
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
3. Remove mounting bracket
4. Remove piston
caliper body
5. Clean the caliper body, piston, and retaining bracket
with brake cleaner or alcohol.
Be sure to clean seal grooves in caliper body.
q
.
BRAKE SYSTEM
w
and dust boot
r t
and square O-rings
y
.
NOTICE
e
.
from the
9
9.21