Replace Rear Brake Pads Or Shoes - Taylor-Dunn B0-248-TT Operation, T Roubleshooting And Replacement Parts Manual

REPLACE REAR BRAKE PADS OR SHOES

NOTE: It is recommended that both the left and right
brake pads be replaced as a set.
NOTE: Installing new brake pads will raise the brake
fluid level in the master cylinder.
1. Make sure the key-switch is in the "OFF"
position, then remove the key.
2. Place the forward-reverse switch in the
center "OFF" position.
3. Confirm the electric park brake is set.
4. Place blocks under the front wheels to
prevent vehicle movement.
5. Disconnect the main positive and
negative cables at the batteries.
Always use a lifting strap, hoist, and jack
stands, of adequate capacity to lift and
support the vehicle. Failure to use lifting
and support devices of rated load capacity
may result in severe bodily injury.
6. Thoroughly clean the area around the master
cylinder cap.
7. Remove fluid from the master cylinder until it is 1/
2 full.
8. Raise the rear of the vehicle and support with jack
stands.
9. Remove the tire/wheel assembly.
Tires and Wheels
NOTE: Refer to
information on removing the tire and wheel
assembly.
10. Release the park brake (wheel brake only).
11. Remove the brake body bolts and discard the lock
nuts and brake pads.
12. Remove the spacer bushings from the mounting
bracket and discard.
13. Inspect the brake rotor. Refer to
Service Brake
section for information regarding
inspecting the brake rotor.
Maintenance, Service, and Repair
Current Taylor-Dunn
free. However, there is the possibility that
the original brakes were replaced with
aftermarket parts containing asbestos.
Since this possibility exists, all brake parts
should be handled as if they contain
asbestos. Refer to Appendix C for
recommended handling precautions.
14. Inspect the spacers and replace if any wear or
damage is found.
15. Install new spacer bushings in the mounting
bracket.
16. Back off the parking brake adjustment (wheel park
brake only).
17. Install new brake pads in reverse order. Torque
the mounting bolts to 11 ft-lbs.
18. Repeat this procedure for the other wheel.
19. Install the tire/wheel assembly and lower the
vehicle to the ground.
20. Fill the master cylinder to the proper level. Refer
to
information regarding the correct master cylinder
fluid level.
21. Adjust the parking brake (wheel park brake only).
Refer to
22. Set the park brake.
23. Reconnect the main positive and negative cables
at the batteries.
24. Remove the blocks from behind the wheels.
25. Release the park brake and test drive the vehicle.
section for
Inspect the
brakes are asbestos
®
Check Master Cylinder Fluid
Adjust the Parking Brake
section for
section.
Brakes
Page 9