Bearing Inspection; Clutch Inspection - Taylor-Dunn G0-010-00 Service And Replacement Parts Manual

CVT SYSTEM

BEARING INSPECTION

1. Rotate the clutch bearing in both clockwise and
counter-clockwise directions.
• The non-braking bearing should rotate both directions
on the shaft with only a slight amount of drag.
2. Verify there is no binding or rough spots. If problems
are noted continue with disassembly.
5.18

CLUTCH INSPECTION

NOTICE
Remove cover, spring, and spider following instructions
for drive clutch removal, then proceed as follows:
1. Remove the moveable sheave spacer sleeve
Inspect for damage and wear.
2. Remove the moveable clutch sheave
damage and wear.
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
q
.
w
. Inspect for
© Copyright TAYLOR-DUNN