Headlights; Headlight Adjustment; Headlight Bulb Replacement - Taylor-Dunn G0-010-00 Service And Replacement Parts Manual

HEADLIGHTS

HEADLIGHT ADJUSTMENT

The headlights are adjustable.
1. Place the vehicle on a level surface with the headlight
approximately 25 ft. (7.6 m) (Item 1) from a wall.
2. Measure the distance from the floor to the center of
the headlight (X1) and make a mark on the wall at the
same height (X2).
3. With the machine in Park and wheels chocked, start
the engine and turn the headlight switch on.
4. The most intense part of the headlight beam should
be aimed 8 in. (20 cm) (item 2) below the mark placed
on the wall in Step 2.
NOTE
Rider weight must be included in the seat while
performing this procedure.
5. Locate the T25 Torx-head adjustment screw through
the wheel well (see illustration). Adjust the beam to
the desired position by loosening the adjustment
screw and moving the lamp to the appropriate height.
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
6. Once the beam is set to the position, tighten the
adjustment screw. Repeat the procedure to adjust the
other headlight.
WARNING
Due to the nature of light utility vehicles and where they
are operated, headlight lenses become dirty. Frequent
washing is necessary to maintain lighting quality. Riding
with poor lighting can result in severe injury or death.

HEADLIGHT BULB REPLACEMENT

1. Open the hood
2. Locate the bulb on the back side of headlight
3. Turn the bulb counterclockwise to remove it
4. Unplug the headlight bulb from the wiring harness. Be
sure to pull on the connector, not on the wiring.
NOTE
Do not touch Headlight bulb glass or premature failure
will occur.
ELECTRICAL
11
11.13