Assembly View; Rear Stabalizer Bar / Linkage; Removal / Installation - Taylor-Dunn G0-010-00 Service And Replacement Parts Manual

STEERING / SUSPENSION

REAR STABALIZER BAR / LINKAGE

REMOVAL / INSTALLATION

1. Elevate and safely support vehicle with weight
removed from the rear wheel(s).
2. Remove the retaining nut
of the stabilizer bar linkage bushing on each side of
the vehicle.
3. Remove the two fasteners
stabilizer bar to the main frame on each side.
4. Remove the stabilizer bar from the frame and inspect
the stabilizer bar for straightness.
5. Inspect the stabilizer bar bushings and replace if
needed.
6. Inspect the rubber bushings on the stabilizer linkage
rod and replace if needed. If replacing the stabilizer
linkage, remove the lower shock bolt from the upper
A-arm.
7. Reverse this procedure for installation.
8. Torque the stabilizer retaining bolts and upper rubber
bushing nuts to specification.
9. If the stabilizer linkage was removed, torque the
lower shock retaining bolt to specification.
8.14
q
from the upper portion
w
that secure the

ASSEMBLY VIEW

REF. DESCRIPTION
Lower A-Arm
q
w Stabilizer Bar
Linkage
e Stabilizer Bar
r Stabilizer Bar
Bushing / Shield
t Nut
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
NOTES
Torque to 17 ft-lbs
(23 Nm)
© Copyright TAYLOR-DUNN