Ignition / Headlight Switch - Taylor-Dunn G0-010-00 Service And Replacement Parts Manual

• Check the solenoid and relay connectors. Look for
loose wires or bad connections.
• Check for power from the relay connector, to ensure
the solenoid has power to be activated. Check for
power at the ECU and Rear Differential Solenoid
Relay.
• Check the switch wires for loose connections.
• Remove solenoid from rear differential and ensure the
solenoid plunger is actuating.
CAUTION
Do not power the solenoid with 12 Volts for more than 1
second, or damage may occur to solenoid.
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN

IGNITION / HEADLIGHT SWITCH

1. Open the hood (see Chapter 5).
2. Disconnect the ignition
depressing the connector lock and pulling on the
connector. Do not pull on the wiring.
3. Inspect the switch connections and test the switch
for continuity.
• Turn the ignition key to ON LIGHTS. There should be
continuity between switch pins C and D; A, E and F.
• Turn the ignition key to ON. There should be continuity
between switch pins C and D; E and F.
• Turn the ignition key to START. There should be
continuity between switch pins A and B; C and D; E
and F.
ELECTRICAL
switch harness, by
11
11.5