Oil Pump Assembly - Taylor-Dunn G0-010-00 Service And Replacement Parts Manual

ENGINE / COOLING SYSTEM

OIL PUMP ASSEMBLY

1. Clean and dry all parts thoroughly. Apply clean
engine oil to all parts. Do not use gasket sealer on the
pump cover mating surfaces.
a
2. Align the gerotor according to the orientation dots.
3. Place the drive pin
shaft.
w
4. Slide the gerotor onto the drive shaft and lock them
into position on the drive pin.
e
5. Install the washer onto the drive shaft
6. Install the oil pump cover
3.78
a
through the oil pump drive
r
.
t
onto the shaft assembly.
7. Grasp the complete oil pump assembly by the drive
y
shaft and install the assembly into the crankcase.
8. Install the oil pump cover bolts
specification.
TORQUE
Oil Pump Cover Bolts
9 ft-lbs (12 Nm)
9. Install the upper oil pump sprocket spacer
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
u
and torque to
i
.
© Copyright TAYLOR-DUNN