Replace Rear Brake Pads; Hydraulic Disc - Taylor-Dunn ET-3000 Manual

T-48 AC / ET 3000

REPLACE REAR BRAKE PADS

Hydraulic Disc

Note: It is recommended that both the left and right brake pads be replaced
Note: Installing new brake pads will raise the brake fluid level in the master
6. Thoroughly clean the area around the master
cylinder cap.
7. Remove fluid from the master cylinder until it is
1/2 full.
8. Raise the rear of the vehicle and support with jack
stands.
MB-T48-02
Current Taylor-Dunn
possibility that the original brakes were replaced with aftermarket
parts containing asbestos. Since this possibility exists, all brake parts
should be handled as if they contain asbestos. Refer to appendix C
for recommended handling precautions.
as a set.
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. If equipped with a hand operated park brake, set the brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
cylinder.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.
brakes are asbestos free. However, there is the
®
Master cylinder is located between the front
seats. Dual reservoir shown.
Brakes
Page 11