Taylor-Dunn G0-010-00 Service And Replacement Parts Manual page 84

ENGINE / COOLING SYSTEM
22. Press in a new water pump drive shaft bearing
until it is fully seated in the cover.
CAUTION
Be sure bearing is fully seated in cover or severe
engine damage may result.
23. Clean and de-grease the water pump drive shaft.
24. Press in the water pump drive shaft into the bearing
using PU-50869.
3.24
a
25. Install the water pump drive shaft holding tool in kit
PU-50869. Hold the tool in position and flip the
assembly up-side-down so the special tool PU-50869
is supporting the assembly.
26. Lubricate the new water pump oil seal with clean
engine oil.
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN