Taylor-Dunn G0-010-00 Service And Replacement Parts Manual page 86

ENGINE / COOLING SYSTEM
32. Apply a small amount of crankcase sealant to the
g
area indicated below
REF. DESCRIPTION
h Crankshaft
j Driveshaft
k Mechanical Seal
l Impeller
33. If needed, install the stator cover removal handles
tool PA-49317 to the water cover bolt holes to aid in
stator cover installation.
3.26
.
NOTES
34. While installing the stator cover to the engine, slightly
rotate the water pump impeller to verify the crankshaft
slot and the water pump drive shaft blade are
properly engaged. Verify the stator cover is laying flat
on the engine case.
CAUTION
The flywheel contains powerful magnets. Use caution
when installing the stator cover.
DO NOT place fingers between cover and crankcase at
any time during the removal and installation process or
injury could result.
CAUTION
If the water pump drive shaft blade and slot in the crank
shaft are not in alignment during the installation
process, severe engine damage may result.
35. Install and torque the stator cover fasteners in
sequence to specification.
TORQUE
Stator Cover and Water Pump Cover:
9 ft-lbs (12 Nm)(Apply Loctite® 204™ to bolt
threads)
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN