Table of Contents
Advertisement
STATOR REMOVAL
NOTICE
Test stator wire continuity before removing it from the
housing.
1. Remove the stator cover as outlined in the "Water
Pump Mechanical Seal / Oil Seal Replacement"
procedure" in this chapter.
CAUTION
The flywheel contains powerful magnets. Use caution
when removing the stator cover.
DO NOT place fingers between cover and crankcase at
any time during the removal process or injury could
result.
Be sure engine coolant does not contaminate the
engine oil during stator cover service.
CAUTION
Never strike flywheel with hammer or drop.
Demagnetization may occur.
Remove and discard the stator cover gasket.
CAUTION
Be sure engine coolant does not contaminate the
engine oil during stator cover service.
q
2. Remove the 3 bolts
that secure the stator to the
stator cover.
w
3. Remove the 2 bolts
that secure the stator wire
routing bracket to the stator cover.
e
4. Remove the stator
from the stator cover.
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
ENGINE / COOLING SYSTEM
STATOR / STATOR COVER INSTALLATION
1. Clean and degrease screws and threads in stator
housing.
2. Clean mounting surfaces of stator and housing.
3. Apply crankcase sealant to edges of rubber stator
grommet as shown below.
4. Set the stator in housing and press wire grommet into
slot on housing.
5. Apply Loctite® 242™ to end (8-10 threads) of three
q
stator screws
and the two wire routing bracket
w
screws
.
6. Install all five screws and torque to specification.
TORQUE
Stator Cover Bolts
9 ft-lbs (12 Nm)Apply Loctite® 242™
TORQUE
Stator Wire Bracket Bolts
6 ft-lbs (8 Nm)Apply Loctite® 242™
7. Install a new stator cover gasket into the engine.
8. Install the stator cover as outlined in this chapter.
CAUTION
The flywheel contains powerful magnets. Use caution
when installing the stator cover.
DO NOT place fingers between cover and crankcase at
any time during the removal process or injury could
result.
3
3.75
Advertisement
Chapters
Table of Contents
Troubleshooting
