Taylor-Dunn G0-010-00 Service And Replacement Parts Manual page 134

ENGINE / COOLING SYSTEM
q
2. Clean flywheel taper
3. Apply a small amount of PS4 engine oil to the flat
w
area on the MAG side crankshaft. DO NOT apply
engine oil to the crankshaft taper.
4. Rotate crankshaft so the flywheel key slot
upward and install crankshaft key.
3.74
to remove all oil or grease.
e
is facing
5. Fully install the Freewheel gear (starter gear) onto the
crankshaft as shown.
IMPORTANT
Do NOT apply loctite to the taper.
6. Align the flywheel keyway with flywheel key on the
crankshaft.
7. By hand, lightly press the flywheel inward while
rotating the freewheel gear counter clock-wise. Fully
install the flywheel until seated on the crankshaft
taper.
8. Install the flywheel washer.
9. Hold flywheel with commercially available strap
wrench.
10. Torque new flywheel nut
TORQUE
Flywheel Retaining Nut:
133 ft-lbs (180 Nm)Torque to specification, back of
180 degrees, retorque to specification.
11. Install starter idler gear and shaft
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
r
to specification.
t
.
© Copyright TAYLOR-DUNN