Oil Pump Removal - Taylor-Dunn G0-010-00 Service And Replacement Parts Manual

ENGINE / COOLING SYSTEM

OIL PUMP REMOVAL

1. Remove the fasteners
(mag) portion of the crank case
section of the crank case.
2. Rotate the crankshaft to TDC position by aligning the
w
timing hole in crankcase with a timing hole in the
crankshaft. Insert a 1/4" drive socket extension
through the crankcase and into the crankshaft
locating hole.
3. Remove the oil pump sprocket bolts
Discard the bolts and replace with new for assembly.
Remove the sprockets and chain
3.76
q
retaining the intermediate
w
and remove this
e
and washers.
r
from the engine.
4. Inspect the oil pump chain for worn or missing rollers
or damage. Chain should be replaced as a set with
sprockets if sprocket teeth are worn.
NOTICE
The larger oil pump sprocket
shaft extension, the smaller oil pump sprocket
mounts to the oil pump shaft.
5. Remove the upper oil pump sprocket spacer
6. Remove the three bolts
cover to the crankcase.
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
t
mounts to the balance
y
u
.
i
securing the oil pump
© Copyright TAYLOR-DUNN