Brake Burnishing Procedure - Taylor-Dunn G0-010-00 Service And Replacement Parts Manual

BRAKE SYSTEM
14. Repeat Steps 9 - 13 for the remaining brake calipers.
15. Install master cylinder reservoir cover.
16. Field test machine at low speed before putting into
service. Check for proper braking action and pedal
reserve. With pedal firmly applied, pedal reserve
should be no less than 1/2"(1.3 cm).
17. Check brake system for fluid leaks.

BRAKE BURNISHING PROCEDURE

It is required that a burnishing procedure be performed
after installation of new brake pads to extend service life
and reduce noise.
Test drive machine and slowly increase speed to above
20 mph. Gradually apply brakes to stop machine. Allow
pads and disc to cool sufficiently during the procedure.
Do not allow pads or disc to become hot or warping may
result. Repeat this procedure 10 times to maximize pad
service life.
9.10
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN