Starter Solenoid Bench Test; Starter Solenoid Operation - Taylor-Dunn G0-010-00 Service And Replacement Parts Manual

STARTER SOLENOID BENCH TEST

Test the start solenoid by powering the solenoid using
battery voltage for a maximum of 5 seconds. With the
solenoid energized, there should be continuity between
terminals (A) and (B). If there is no continuity or high
resistance, replace the starter solenoid.
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN

STARTER SOLENOID OPERATION

To energize the starter solenoid the following must occur:
• The brake must be applied to provide a ground path
via the Brown / Yellow wire.
• The key switch must be turned to the "start" position to
provide 12V power via the White / Red wire.
• Once the pull-in coil is energized, the solenoid
provides a current path for 12V power to reach the
starter motor.
ELECTRICAL
11
11.29