ENGINE DISASSEMBLY / INSPECTION - TOP END
VALVE COVER REMOVAL
NOTICE
The valve cover, camshafts, cylinder head, cylinder and
piston can be serviced with the engine installed in the
chassis.
1. If needed, remove the spark plug wire from the
engine.
2. Remove dirt and debris from valve cover area.
3. Remove the four valve cover bolts
4. Carefully lift valve cover from the engine and remove
it out of the right-hand rear wheel well area.
w
5. Replace valve cover seal
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
CAMSHAFT / CARRIER REMOVAL
1. Rotate the engine so the piston is at Top Dead Center
q
.
2. Remove the hydraulic cam chain tensioner
if oil leaks are evident.
3. Remove the camshaft sprocket bolt
ENGINE / COOLING SYSTEM
NOTICE
The camshafts can be removed with the engine
installed in the chassis.
(TDC) on the compression stroke.
NOTICE
To verify TDC, see
Setting TDC (Top-Dead-Center) page 3.15
the cylinder. Replace the sealing washer
reassembly.
engine from turning. Pull the camshaft sprocket
of the camshaft and remove the timing chain from the
sprocket. Carefully remove the camshaft from the
engine.
3
e
from
r
upon
u
while holding
i
off
3.45