Engine Assembly - Lower End - Taylor-Dunn G0-010-00 Service And Replacement Parts Manual

ENGINE / COOLING SYSTEM

ENGINE ASSEMBLY - LOWER END

CRANKCASE ASSEMBLY – PTO SIDE
1. Lubricate all crankcase bearings with engine oil.
Clean sealing surface to remove all oil sealant.
NOTICE
Apply Loctite® 641 to the inner race of each of the
crank bearings.
2. Place crankcase on a sturdy work bench.
3. Carefully set the PTO crankcase onto the PTO side of
the crankshaft.
4. Align the connecting rod with the cylinder area of the
crankcase.
5. Install the crankshaft removal / installation tool on to
the PTO side crankcase.
Crankshaft Removal / Installation Tool
PU-50784
q
• Install plate over adapter
• Evenly attach the assembly
crankcase flange using the four bolts provided with
tool.
• Place the nut and large washer onto the crankshaft
e
installation screw
• Insert the crankshaft installation screw through the
threaded portion of the adaptor
3.84
w
.
q
onto the PTO side
.
w
.
• Fully thread the crankshaft installation screw into
the clutch bolt threads of the crankshaft.
• With the help of an assistant holding the
crankshaft, firmly hold the crankshaft installation
screw with a wrench while tightening the large nut
against the adaptor
6. With the help of an assistant, slowly tighten the nut
until the crankshaft is completely seated into the
crankcase bearings.
7. Remove the crankshaft removal / installation tool
from the crankcase.
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
w
.
© Copyright TAYLOR-DUNN