Transmission Service; Transmission Removal - Taylor-Dunn G0-010-00 Service And Replacement Parts Manual

TRANSMISSION SERVICE

TRANSMISSION REMOVAL

CAUTION
Serious injury may result if machine tips or falls. Be
sure machine is secure before beginning this
procedure. Always wear eye protection.
1. Remove the cargo box and seat (see Chapter 5).
2. Disconnect the (-) negative battery cable from the
battery.
3. Raise and support the vehicle.
4. Remove rear wheels from the vehicle.
5. If internal transmission repair is required, drain the
transmission lubricant (see Chapter 2).
6. Remove the air box mounting bolt
7. Remove the breather hose
e
duct clamps , remove the duct mounting bolt
t
remove the intake duct .
8. Disconnect the main harness from the ETC and TPS
at the throttle body.
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
9. Loosen the air box to throttle body clamp
q
.
10. Remove the outer clutch cover, drive belt, drive
11. Remove driveshaft from both sides (see Chapter 7).
12. Place a spacer or support between the vehicle frame
w
, loosen the air intake
r
and
13. Remove vent hose from transmission.
u
move the air box assembly
the driver's seat.
clutch, driven clutch, inner clutch cover and clutch
outlet duct (see Chapter 6).
CAUTION
Be sure to use the correct Drive Clutch Puller (PA-
48595) to prevent damage to crankshaft.
and engine to hold the engine up in position.
TRANSMISSION
y
and
out of the way towards
6
6.9