Crankshaft Removal - Taylor-Dunn G0-010-00 Service And Replacement Parts Manual

ENGINE / COOLING SYSTEM
5. Inspect / replace the balance shaft bearings in both
crankcase halves.
Inspection / Removal" procedure in this chapter.
NOTICE
Due to extremely close tolerances and minimal wear,
counterbalance shaft ball bearings must be inspected
visually and by feel. Look for signs of discoloration,
scoring or galling. Turn the inner race of each bearing.
The bearings should turn smoothly and quietly. The
outer race of each bearing should fit tightly in the
crankcase bore. The inner race should be firm with
minimal side to side movement and no detectable up
and down (radial) movement.
3.82
See "Crankcase Bearing

CRANKSHAFT REMOVAL

1. Remove the engine from the engine stand and place
the assembly on a sturdy work bench.
2. Install the crankshaft removal / installation tool on to
the PTO side crank case.
Crankshaft Removal / Installation Tool: PU-50784
• Install plate "A" over adapter "B".
• Evenly attach the assembly onto the PTO side
crankcase using the (x4) bolts as shown below.
• Thread the crankshaft removal screw "C" into
adapter "B".
3. With the help of an assistant holding the crankshaft,
slowly tighten the screw "C" until the crankcase is
completely separated from the crankshaft.
4. Remove all special tools from the crankcase.
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN