Drive Belt; Belt Removal; Belt Inspection - Taylor-Dunn G0-010-00 Service And Replacement Parts Manual

DRIVE BELT

BELT REMOVAL

NOTE
Inspect the entire clutch outlet duct when replacing a
drive belt. Remove any debris found in the duct.
1. Remove the (8) screws that retain the outer clutch
cover.
2. Maneuver the outer clutch cover outward to access
the drive belt.
3. Mark the drive belt direction of rotation so that it can
be installed in the same direction.
4. Remove the driven clutch mounting bolt.
5. Remove the outer sheave.
6. Remove the belt from the vehicle.
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN

BELT INSPECTION

1. Inspect belt for hour glassing (extreme circular wear
in at least one spot and on both sides of the belt).
Hour glassing occurs when the drive train does not
move and the drive clutch engages the belt.
2. Inspect belt for loose cords, missing cogs, cracks,
abrasions, thin spots, or excessive wear. Compare
belt measurements with a new drive belt. Replace if
necessary.
3. Belts with thin spots, burn marks, etc., should be
replaced to eliminate noise, vibration, or erratic CVT
operation. See the Troubleshooting Chart at the end
of this chapter for possible causes.
CVT SYSTEM
5
5.9