Clutch Alignment / Offset / Center Distance; Inspection; Adjustment - Taylor-Dunn G0-010-00 Service And Replacement Parts Manual

CLUTCH ALIGNMENT / OFFSET / CENTER DISTANCE

INSPECTION

1. Remove the outer CVT cover, drive belt, drive clutch
and driven clutch as outlined in this chapter.
NOTE
The inner CVT cover does not need to be removed to
check the clutch center to center distance.
2. Install the Clutch Center Distance Tool onto the
crankshaft and transmission input shaft. The G-100
uses the holes marked with a 3. The pictures below
show a properly installed tool.
Clutch Center Distance Tool
PU-50658 or PU-50658-A
NOTE
Images for Reference only. The tool shown should only
be used to check center to center distance.
The location the tool rests on the shafts may vary.
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN

ADJUSTMENT

1. Remove the Clutch Center Distance tool from the
engine and transmission.
2. Remove the inner CVT Cover.
3. Loosen the eight engine to transmission coupler bolts
q
.
4. Loosen the two fasteners
transmission isolator to the vehicle frame.
5. With the engine and transmission mounting fasteners
loose, install the Clutch Center Distance Tool as
shown in the inspection process.
Clutch Center Distance Tool
PU-50658
CVT SYSTEM
5
w
securing the rear
5.11