Taylor-Dunn G0-010-00 Service And Replacement Parts Manual page 235

4. Install the Clutch Center Distance Tool (PU-50658)
onto the crankshaft and transmission input shaft to
properly position the clutch center distance. The
pictures below show the tool (PU-50658) properly
installed.
5. In sequence, torque the eight engine coupler bracket
fasteners to specification.
TORQUE
Engine to Trans Coupler Fasteners
In Sequence:55 ft-lb (75 Nm)
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
6. Remove the clutch center distance tool.
7. Remove the spacer or support between the vehicle
frame and engine.
8. Install and properly route the gear position switch
i
connector , speed sensor connector
position sensor connector, shift bracket bolts
s
bracket , shift cable clevis pin and washer
the transmission.
9. Torque the two shift cable bracket bolts to
specification.
TORQUE
Shift Cable Bracket Bolts:
37 ft-lbs (50 Nm)
10. Install three wire ties to retain wire harness to
transmission and mounts.
11. Install and properly route the vent hose.
12. Install inner clutch cover, outlet duct, drive clutch,
driven clutch, belt and outer clutch cover (see
Chapter 6).
TRANSMISSION
o
, crankshaft
a
, shift
d
onto
6
6.11