Engine Air Intake Inspection; Cvt Air Intake Inspection - Taylor-Dunn G0-010-00 Service And Replacement Parts Manual

3. Remove the air filter assembly. Inspect the air filter
and replace if necessary.
NOTICE
If the filter has been soaked with fuel or oil it must be
replaced. Do not attempt to wash the air filter. If
cleaning is required, replace the filter.
REF. DESCRIP-
TION
w Cover
e Filter
r Seal
t Clamp
Airbox
y
u Boot
Installation
4. Clean airbox of any oil or water deposits and apply a
small amount of grease to the sealing surfaces of the
filter.
5. Reinstall the air filter into the airbox container. Be
sure the filter fits tightly in the air box and engage the
(2) clips.
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN

ENGINE AIR INTAKE INSPECTION

1. Remove the cover from the outer side of the seat
base
2. If the pre-filter element is dirty, clean it with hot, soapy
water. Rinse and dry the filter element thoroughly.
Inspect element for tears or damage. Replace if
necessary.
3. Reinstall the pre-filter element into the seat frame and
NOTES
install the cover.

CVT AIR INTAKE INSPECTION

1. Remove the CVT intake cover
2. Verify there is no debris obstructing the airway.
3. Reinstall the cover.
MAINTENANCE
q
and remove the pre-filter element.
q
.
2
2.21