Line / Hose Routing; Fuel Line Routing; Vent Line Termination Fitting - Taylor-Dunn G0-010-00 Service And Replacement Parts Manual

FUEL SYSTEM

LINE / HOSE ROUTING

FUEL LINE ROUTING

q w
• The fuel supply line is routed as shown below and retained by a clip at the front engine mount.
e r
• The fuel vent line is routed as shown below and terminates at the fuel vent connector that is inserted in the
frame.
4

VENT LINE TERMINATION FITTING

NOTICE
This fitting should be inspected and tested using a Mity
If the vent line fitting is removed from the frame, it must
Vac™ to ensure proper venting. Connect the Mity Vac to
be replaced. The ears on the clip (arrows) will not hold
the fitting and give it 5 pumps. The gauge should return
properly once it is removed.
to 0 immediately or there is an obstruction.
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
4.9
© Copyright TAYLOR-DUNN