Keithley 708B Reference Manual page 96

Models 707B and 708B Switching Matrix Reference Manual
To create a scan list from the web interface:
1. From the left navigation of the web interface Home page, select Scan Builder.
2. In the Add Channel By list on the right, select Number to add the channels individually or Pattern
to select patterns.
3. If you selected Pattern, select a pattern from the Channel Pattern list.
4. If you selected Number, select the channel numbers from the list. You can use Ctrl+click to select
multiple channels and Shift+click to select a range of channels. To remove your selections from
the Add Channel By list, click Clear Channel Selection.
5. Click Add Step. The channels and patterns are added to the Steps list.
6. In the Scan Count box, enter the number of times you want to repeat the steps in the scan.
7. Repeat these steps as needed to build the scan steps. The scan is saved as you build it.
Clear the scan list from the web interface
Clearing the scan list deletes all channels and channel patterns from the scan list.
To clear the scan list from the web interface:
1. From the left navigation area of the web interface home page, select Scan Builder.
2. Click Scan Clear.
Review the scan list
You can review the existing scan list to see which channels and channel patterns are listed, and in
which order.
To review the scan list from the web interface:
1. From the left navigation of the web interface Home page, select Scan Builder.
2. Select the Build & Run tab. The scan list is shown in the Steps box.
Reset the scan list
You can clear the scan list and return scan settings to their factory defaults using scan reset. A scan
reset does not affect any settings in the instrument except the scan list and trigger model.
707B-901-01 Rev. A / August 2010
Section 2: General operation
2-77