Trigger.blender[N].Stimulus[M] - Keithley 708B Reference Manual

Section 7: Command reference
Also see
trigger.blender[N].orenable
trigger.blender[N].overrun

trigger.blender[N].stimulus[M]

trigger.blender[N].stimulus[M]
This attribute specifies which events trigger the blender.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
eventID = trigger.blender[N].stimulus[M]
trigger.blender[N].stimulus[M] = eventID
eventID
N
M
Details
There are four acceptors that can each select a different event. The eventID parameter can be the event ID of
any trigger event.
The eventID parameter may be one of the existing trigger event IDs shown in the following table.
Trigger event IDs
Trigger event ID
digio.trigger[N].EVENT_ID
display.trigger.EVENT_ID
trigger.EVENT_ID
trigger.blender[N].EVENT_ID
trigger.timer[N].EVENT_ID
tsplink.trigger[N].EVENT_ID
lan.trigger[N].EVENT_ID
scan.trigger.EVENT_SCAN_READY
scan.trigger.EVENT_SCAN_START
scan.trigger.EVENT_CHANNEL_READY
scan.trigger.EVENT_SCAN_COMP
scan.trigger.EVENT_IDLE
7-204
(on page 7-202)
(on page 7-203)
(on page 7-204)
Affected by
System reset
Trigger blender N reset
The event that triggers the blender action; see Details
The trigger event blender (1 or 2)
The stimulus index (1 to 4)
Description
An edge (either rising, falling, or either based on the
configuration of the line) on the digital input line
The trigger key on the front panel is pressed
A *trg message on the active command interface. If GPIB is
the active command interface, a GET message also
generates this event
A combination of events has occurred
A delay expired
An edge (either rising, falling, or either based on the
configuration of the line) on the TSP-Link trigger line
A LAN trigger event has occurred
Scan ready event
Scan start event
Channel ready event
Scan complete event
Idle event
Models 707B and 708B Switching Matrix Reference Manual
Where saved Default value
Create 0
configuration script
707B-901-01 Rev. A / August 2010