Scan.bypass - Keithley 708B Reference Manual

Models 707B and 708B Switching Matrix Reference Manual
state
scanCount
stepCount
Details
Before using this command, use scan.create() and scan.add()or scan.addimagestep() to set up a
scan list.
When the scan is run in the background, you must use the scan.state() function to check the status of the
scan.
Example
scan.background()
Also see
scan.add() (on page 7-142)
scan.create()
scan.execute()
scan.list() (on page 7-148)
scan.state() (on page 7-152)

scan.bypass

This attribute indicates whether the first channel of the scan waits for the channel stimulus event to be satisfied
before closing.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
bypass = scan.bypass
scan.bypass = bypass
bypass
707B-901-01 Rev. A / August 2010
The result of scanning:
scan.EMPTY or 0
scan.BUILDING or 1
scan.RUNNING or 2
scan.ABORTED or 3
scan.FAILED or 4
scan.FAILED_INIT or 5
scan.SUCCESS or 6
The present number of scans completed
The present number of steps completed
(on page 7-146)
(on page 7-147)
Affected by
System reset
Scan reset
The state of the bypass. Set to one of the following values:
scan.OFF or 0: Bypass disabled
scan.ON or 1: Bypass enabled
Runs a scan in the background
Where saved
Create
configuration script
Section 7: Command reference
Default value
Scan.ON
7-145