Lan.trigger[N].Ipaddress; Lan.trigger[N].Mode - Keithley 708B Reference Manual

Models 707B and 708B Switching Matrix Reference Manual

lan.trigger[N].ipaddress

This attribute specifies the address (in dotted-decimal format) of UDP or TCP listeners.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
ipAddress = lan.trigger[N].ipaddress
lan.trigger[N].ipaddress = ipAddress
ipAddress
N
Details
Sets the IP address for outgoing trigger events.
Set to "0.0.0.0" for multicast.
After changing this setting, the lan.trigger[N].connect() command must be called before outgoing
messages can be sent.
Example
lan.trigger[3].protocol = lan.TCP
lan.trigger[3].ipaddress = "192.168.1.100"
lan.trigger[3].connect()
Also see
lan.trigger[N].connect()

lan.trigger[N].mode

This attribute sets the trigger operation and detection mode.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
mode = lan.trigger[N].mode
lan.trigger[N].mode = mode
mode
N
707B-901-01 Rev. A / August 2010
Affected by
System reset
LAN trigger N reset
The LAN address for this attribute as a string in dotted decimal notation
A number specifying the LAN event number (1 to 8)
(on page 7-116)
Affected by
System reset
LAN trigger N reset
A number representing the LAN event number (1 to 8); see the Details
section for more information
A number representing the trigger mode (0 to 7)
Where saved Default value
Create "0.0.0.0"
configuration script
Where saved Default value
Create lan.TRIG_EITHER
configuration script
Section 7: Command reference
7-119