Keithley 708B Reference Manual page 373

Section 7: Command reference
Details
This attribute controls the mode in which the trigger event detector and the output trigger generator operate on
the given trigger. These settings are intended to provide behavior similar to the digital I/O triggers.
mode settings
Full
lan.TRIG_EITHER
lan.TRIG_FALLING
lan.TRIG_RISING
lan.TRIG_RISINGA
lan.TRIG_RISINGM
lan.TRIG_SYNCHRONOUS
lan.TRIG_SYNCHRONOUSA
lan.TRIG_SYNCHRONOUSM
Details
lan.TRIG_RISING and lan.TRIG_RISINGA are the same.
lan.TRIG_RISING and lan.TRIG_RISINGM are the same.
lan.TRIG_SYNCHRONOUS is provided for compatibility with the digital I/O and TSP-Link triggering on older
firmware. Use of lan.TRIG_SYNCHRONOUSA or lan.TRIG_SYNCHRONOUSM (instead of
lan.TRIG_SYNCHRONOUS) is preferred.
Example
print(lan.trigger[1].mode)
Also see
digio functions and attributes
tsplink functions and attributes
7-120
Models 707B and 708B Switching Matrix Reference Manual
Number Trigger packets detected as input
0 Rising or falling edge (positive or
negative state)
1 Falling edge (negative state)
2 Rising edge (positive state)
3 Rising edge (positive state)
4 Rising edge (positive state)
5 Falling edge (negative state)
6 Falling edge (negative state)
7 Rising edge (positive state)
Returns the present LAN trigger mode of LAN
event 1.
(on page 5-9)
(on page 5-16)
LAN trigger packet
generated for output
with a...
negative state
negative state
positive state
positive state
positive state
positive state
positive state
negative state
707B-901-01 Rev. A / August 2010