Tsplink.trigger[N].Mode - Keithley 708B Reference Manual

Section 7: Command reference
Details
This number is used by the TSP-Link trigger line when it detects an input trigger.
Set the stimulus of any trigger event detector to the value of this constant to have it respond to trigger events
from this line.
Also see
None

tsplink.trigger[N].mode

This attribute defines the trigger operation and detection mode.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
mode = tsplink.trigger[N].mode
tsplink.trigger[N].mode = mode
mode
N
Details
This attribute controls the mode in which the trigger event detector and the output trigger generator operate on
the given trigger line.
The setting for mode can be one of the following values:
Mode values
Mode
tsplink.TRIG_BYPASS
tsplink.TRIG_FALLING
tsplink.TRIG_RISING
tsplink.TRIG_EITHER
tsplink.TRIG_SYNCHRONOUSA
tsplink.TRIG_SYNCHRONOUS
7-220
Models 707B and 708B Switching Matrix Reference Manual
Affected by
System reset
TSP-Link trigger N reset
The trigger mode
The trigger line (1 to 3)
Number Description
value
Allows direct control of the line as a digital I/O line.
0
1 Detects falling-edge triggers as input. Asserts a TTL-low pulse
for output.
2 If the programmed state of the line is high, the
tsplink.TRIG_RISING mode behaves similar to
tsplink.TRIG_RISINGA. If the programmed state of the line
is low, the tsplink.TRIG_RISING mode behaves similar to
tsplink.TRIG_RISINGM. Use digio.TRIG_RISINGA if
the line is in the high output state. Use
digio.TRIG_RISINGM if the line is in the low output state.
3 Detects rising- or falling-edge triggers as input. Asserts a
TTL-low pulse for output.
Detects the falling-edge input triggers and automatically
4
latches and drives the trigger line low.
5 Detects the falling-edge input triggers and automatically
latches and drives the trigger line low. Asserts a TTL-low pulse
as an output trigger.
Where saved Default value
Create TRIG_BYPASS
configuration script
707B-901-01 Rev. A / August 2010