Keithley 708B Reference Manual page 377

Section 7: Command reference
Trigger event IDs
Trigger event ID
digio.trigger[N].EVENT_ID
display.trigger.EVENT_ID
trigger.EVENT_ID
trigger.blender[N].EVENT_ID
trigger.timer[N].EVENT_ID
tsplink.trigger[N].EVENT_ID
lan.trigger[N].EVENT_ID
scan.trigger.EVENT_SCAN_READY
scan.trigger.EVENT_SCAN_START
scan.trigger.EVENT_CHANNEL_READY
scan.trigger.EVENT_SCAN_COMP
scan.trigger.EVENT_IDLE
Use the EVENT_ID constant to set the stimulus attribute rather than using a numerical value for the
EVENT_ID constant. Doing this will make your code compatible for possible upgrades if the
EVENT_ID changes in future enhancements to the instrument.
Setting this attribute to zero disables automatic trigger generation.
If any events are detected prior to calling lan.trigger[N].connect(), the event is ignored and the action
overrun is set.
Example
lan.trigger[5].stimulus
trigger.timer[1].EVENT_ID
Also see
lan.trigger[N].assert()
lan.trigger[N].clear()
lan.trigger[N].connect()
lan.trigger[N].overrun
lan.trigger[N].wait()
7-124
=
(on page 7-114)
(on page 7-115)
(on page 7-116)
(on page 7-121)
(on page 7-125)
Models 707B and 708B Switching Matrix Reference Manual
Description
An edge (either rising, falling, or either based on the
configuration of the line) on the digital input line
The trigger key on the front panel is pressed
A *trg message on the active command interface. If GPIB is
the active command interface, a GET message also
generates this event
A combination of events has occurred
A delay expired
An edge (either rising, falling, or either based on the
configuration of the line) on the TSP-Link trigger line
A LAN trigger event has occurred
Scan Ready Event
Scan Start Event
Channel Ready Event
Scan Complete Event
Idle Event
NOTE
Use timer 1 trigger event as the
source for LAN packet 5 trigger
stimulus.
707B-901-01 Rev. A / August 2010