Keithley 708B Reference Manual page 477

Section 7: Command reference
Also see
tsplink.trigger[N].pulsewidth
tsplink.trigger[N].mode
tsplink.trigger[N].overrun
tsplink.trigger[N].stimulus
tsplink.trigger[N].stimulus
This attribute specifies the event that causes the synchronization line to assert a trigger.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
eventID = tsplink.trigger[N].stimulus
tsplink.trigger[N].stimulus = eventID
eventID
N
Details
To disable automatic trigger assertion on the synchronization line, set this attribute to 0.
Do not use this attribute when triggering under script control. Use tsplink.trigger[N].assert() instead.
The eventID parameter may be one of the existing trigger event IDs shown in the following table.
Trigger event IDs
Trigger event ID
digio.trigger[N].EVENT_ID
display.trigger.EVENT_ID
trigger.EVENT_ID
trigger.blender[N].EVENT_ID
trigger.timer[N].EVENT_ID
tsplink.trigger[N].EVENT_ID
lan.trigger[N].EVENT_ID
scan.trigger.EVENT_SCAN_READY
scan.trigger.EVENT_SCAN_START
scan.trigger.EVENT_CHANNEL_READY
scan.trigger.EVENT_SCAN_COMP
scan.trigger.EVENT_IDLE
7-224
(on page 7-222)
(on page 7-220)
(on page 7-221)
(on page 7-224)
Affected by
System reset
TSP-Link trigger N reset
The event identifier for the triggering event
The trigger line (1 to 3)
Description
An edge (either rising, falling, or either based on the
configuration of the line) on the digital input line
The trigger key on the front panel is pressed
A *trg message on the active command interface. If GPIB is
the active command interface, a GET message also
generates this event
A combination of events has occurred
A delay expired
An edge (either rising, falling, or either based on the
configuration of the line) on the TSP-Link trigger line
A LAN trigger event has occurred
Scan ready event
Scan start event
Channel ready event
Scan complete event
Idle event
Models 707B and 708B Switching Matrix Reference Manual
Where saved Default value
Create 0
configuration script
707B-901-01 Rev. A / August 2010