Section 2: General operation
To enable sequential connections through the front panel interface:
1. Press the MENU key.
2. Use the navigation wheel to scroll to the CHANNEL menu item.
3. Press the ENTER key.
4. Select the SEQUENTIAL menu item.
5. Select ON or OFF.
6. Use the ENTER key to apply the selection.
7. Use the EXIT (LOCAL) key to leave the menu.
To enable sequential connections through the web interface:
1. Open the UNIT page.
2. In the upper left corner, select the Sequential check box (next to the Channel Connect Rule list).
To enable sequential connections through the remote command interface:
Send the command:
channel.connectsequential
2-92
Models 707B and 708B Switching Matrix Reference Manual
(on page 7-21)
707B-901-01 Rev. A / August 2010