Keithley 708B Reference Manual page 458

Models 707B and 708B Switching Matrix Reference Manual
Use zero to disable the blender input.
Use the eventID parameter rather than the numeric value to set the stimulus value. This will help
make the code compatible for future upgrades.
Example
digio.trigger[3].mode = digio.TRIG_FALLING
digio.trigger[5].mode = digio.TRIG_FALLING
trigger.blender[1].orenable = true
trigger.blender[1].stimulus[1] = digio.trigger[3].EVENT_ID
trigger.blender[1].stimulus[2] = digio.trigger[5].EVENT_ID
scan.trigger.arm.stimulus = trigger.blender[1].EVENT_ID
Also see
trigger.blender[N].reset()
trigger.blender[N].wait()
This function waits for a blender trigger event to occur.
Type TSP-Link accessible
Function Yes
Usage
triggered = trigger.blender[N].wait(timeout)
triggered
N
timeout
Details
This function waits for an event blender trigger event. If one or more trigger events were detected since the last
time trigger.blender[N].wait() or trigger.blender[N].clear() was called, this function returns
immediately.
After detecting a trigger with this function, the event detector automatically resets and rearms. This is true
regardless of the number of events detected.
707B-901-01 Rev. A / August 2010
NOTE
(on page 7-203)
Affected by
Trigger detection indication for blender
The trigger blender (1 or 2) on which to wait
Maximum amount of time in seconds to wait for the trigger blender event
Generate a trigger blender 1
event when a digital I/O
trigger happens on line 3 or
5.
Set the trigger blender 1
event to start a scan.
Where saved Default value
Section 7: Command reference
7-205