Lan.reset(); Lan.restoredefaults() - Keithley 708B Reference Manual

Models 707B and 708B Switching Matrix Reference Manual

lan.reset()

This function resets the LAN interface.
Type TSP-Link accessible
Function Yes
Usage
lan.reset()
Details
This function resets the LAN interface. It performs the commands lan.restoredefaults() and
lan.applysettings().
Also see
lan.applysettings()

lan.restoredefaults()

lan.restoredefaults()
This function resets LAN settings to default values.
Type TSP-Link accessible
Function Yes
Usage
lan.restoredefaults()
Details
The settings that are restored are shown in the following table.
Settings that are restored on default
ICL attribute
lan.config.dns.address[N]
lan.config.dns.domain
lan.config.dns.dynamic
lan.config.dns.hostname
lan.config.dns.verify
lan.config.gateway
lan.config.ipaddress
lan.config.method
lan.config.subnetmask
lan.lxidomain
localnode.password
This is command is run when lan.reset() is sent.
707B-901-01 Rev. A / August 2010
Affected by
(on page 7-98)
(on page 7-107)
Affected by
Default setting
"0.0.0.0"
""
lan.ENABLE
"K-<model number>-<serial number>"
lan.ENABLE
"0.0.0.0"
"0.0.0.0"
lan.AUTO
"255.255.255.0"
0
"admin"
Where saved Default value
Where saved Default value
Section 7: Command reference
7-107