Scan.abort() - Keithley 708B Reference Manual

Models 707B and 708B Switching Matrix Reference Manual
Details
The
reset()
node and all subordinate nodes.
If you want to reset a specific instrument, use either the
command. The
command is used to reset an instrument on a subordinate node.
When no value is specified for system, the default value is
Resetting the entire system using the
the controlling node. If the node is not the controller, sending this command generates an error.
Example
reset(true)
Also see
localnode.reset()

scan.abort()

This function aborts a running background scan.
Type TSP-Link accessible
Function Yes
Usage
scan.abort()
Details
If no scan is running, the call to this function is ignored.
When a scan is aborted, the channels remain in the opened or closed states they were in when the
scan was aborted.
Example
scan.background()
scan.abort()
Also see
scan.background()
707B-901-01 Rev. A / August 2010
command in its simplest form resets the entire TSP-enabled system, including the controlling
localnode.reset() command is used for the local instrument. The
reset(
(on page 7-131)
Affected by
(on page 7-144)
localnode.reset()
true .
) function is only permitted if the reset command sent from
true
If sent from the controlling node, the entire system is
reset (if not sent from the controlling node, an error
is generated).
Where saved
NOTE
Starts background scan, and then aborts the
scan.
Section 7: Command reference
or node[ ].reset()
X
node[ ].reset()
X
Default value
7-141