Additional Settings Tab - Delphin Expert Logger Manual

Expert Logger
Location
entered here.
Description
a function (software channel), a description of the function appears here
(in English).
Lower section
Copy
copies the settings shown, which you can then adopt in another chan-
inserting
nel by
Previous
next channel in the channel view. The dialogue's current settings are
applied before the dialogue changes (the equivalent of clicking on
OK
: Applies all the settings and closes the dialogue.
Cancel
: Cancels the configuration and closes the dialogue. The settings are
ignored and no changes are made within the device.
Help
: Opens online help. The relevant topic is displayed where available.
The date and time display of the last setting change for the channel is dis-
played in the lower left corner (15.6.2015 in the example).
Tabs in the dialogue's main section
Depending on the type of channel, different tabs are available. Not all the
tabs are available for every channel type. The following (general) tabs are
explained in this section as they are very similar for different devices.
Additional settings
l
Sensor compensation
l
Information
l
Main settings
The
found under the relevant device- and channel type. There are also other
tabs that relate to specific channels, e.g.,
are, therefore, described under these channels.
4.7.1 Additional settings tab
Delphin Technology AG
Info
The unit for memory groups should be left as % (default). Occupied
storage space is always shown as a percentage.
: Information on the position of the sensor or signal source can be
: A description or comment can be entered here. After creating
.
Next
or : Changes to the configuration dialogue of the previous or
tab is always specific to the channel. It can hence be
Extended settings
48
OK ).
Filter
or and
Expert Logger Manual
Januar 2018