Usb Device - Delphin Expert Logger Manual

Expert Logger
on the Ethernet switch to which the
aged switches, the speed can be fixed there too, which means that no
more negotiation will be necessary.
4.12.6
USB device
The device driver is automatically installed when the device is connected to the PC.
Then use the USB device interface (see
nections) in order to connect the device with your PC. The driver simulates
an Ethernet interface with the USB interface of your PC. It is therefore
recommended, in the
DHCP Server
matically a suitable address for this USB interface from the device. The
default settings of the dialogue by themselves allow for easy com-
munications.
If more than one device is connected via the USB interface, the IP addresses of the
USB interface must be adapted to the devices in order to avoid an IP conflict.
With a subnet mask of
address ranges for
IP settings
identical.
If you do not want to use the DHCP server, you must set appropriate IP
addresses both at the USB interface of your PC (via the Network and Shar-
ing Center) and in this dialogue.
Expert Logger Manual
Januar 2018
USB device properties
enabled (default setting), because the PC is assigned auto-
The address used for the
the range specified for
255.255.255.0
DHCP Server
must match, that is, the first three groups of digits must be
Delphin
device is connected. For man-
Delphin
device displays and con-
dialogue, to keep the setting
IP address
DHCP Server
(default setting for
Start/End range
(
239
must not be within
.
Net mask
), the
IP address
) and the
Delphin Technology AG
for