Connecting Slave Devices - Delphin Expert Logger Manual

Expert Logger
The process is displayed in a window:
The process ends when 'OK' is displayed in the window.

4.5 Connecting slave devices

Slave devices can only be connected with
ProfiMessage
(DCP) to connect to I/O modules. A
with two I/O modules. The CAN-connection is established internally.
The DCP CAN bus for I/O extensions uses the "Ext. BUS" port. If a
ProfiMessage
nels, a slave device can then be connected to the
via this port. (Refer to
Connecting the extension bus
Use twisted pair shielded cable (e.g. braided LiYCY 2x0.14 mm2 TP).
Ensure that the start and end connections (i.e. at the master and at the
final slave device) use the supplied 120-ohm resistors. These produce the
bus signal level and prevent interference from signal reflection. The Hi
(CAN High) designated ports must be connected to other devices via Hi,
and Lo (CAN Low) with Lo.
Illustration in DataService Configurator
Channels
The
type of view selected (
"Extension (CAN) bus" group or as I/O modules from the (master) device.
Expert Logger Manual
Januar 2018
A restart can be performed only via the Web inter-
face.
system uses CAN-bus and Delphin CAN Protoco
device has an insufficient number or type of input chan-
Device connections
tab lists the modules currently connected according to the
hardware view
ProfiMessage
ProfiMessage
ProfiMessage
).
user-defined
or
43
devices. The
Delphin
device can be fitted
device
) in the group
Delphin Technology AG
l