Configuring The Network Via The Display - Delphin Expert Logger Manual

Expert Logger
Change channel order via Options → Activate channel move / link (only avail-
l
able in the User-defined view ).
Further information is available in the

4.2 Configuring the network via the display

The settings that you can make in the display relate to the basic setting
required to enable communication via the Ethernet interface. Additional
settings are required for device operation, see
browser configuration or
DataService Configurator.
Tap
you to make the settings for the PC interface:
By tapping on the relevant symbol for LAN2 or WLAN, the corresponding
settings dialogue will open. These are described below:
Expert Logger Manual
Januar 2018
Network settings
After changing the
device is then accessible only via the new address. The
PC's IP address (and any subnet mask) then also
requires amending to establish a connection if
required.
on the display to call the network settings main view. This allows
DataService Configurator
Settings
for configuration via the
IP address subnet mask
or
29
manual.
for Internet
the
Delphin Technology AG