Delphin Expert Logger Manual page 227

Expert Logger
Data type settings
Output is always as an ASCII string. However, you can set the format of
the value to be output using the data type setting.
Data type
l
Sets the data type for the signal that is to be used. The value for other entries
depends on the settings here. For example, the integer data type has no
decimal places, but can be output with post-decimal places, which are then
always zeroes.
For the string data type, enter its length.
Pre-decimal places
l
Sets the number of decimal places before the decimal point/separator. The
decimal separator is output only when at least one post-decimal place is out-
put.
Expert Logger Manual
Januar 2018
227
Delphin Technology AG