Can Connection - Delphin Expert Logger Manual

Expert Logger
Scaling example
In the above image, a conversion takes place from 2 000 (integer value) to
200 (°C), i.e. it returns a decimal point despite transmission of an integer
(whole number).
Using the channel as output
If you create a Modbus channel as an output, you can send data from the
Delphin
Enter the data for the message to be sent in a similar way to a Modbus
input. You must also enter the
Enter either a constant for the
and an existing channel in the device for which a value is to be output.
Selecting
DataService Configurator or automatically set via a
ation. The source type is converted to the type given in
Scaling
also to
Inherit status
is used, but not output to the CAN bus.
Set asynchronous
as soon as the value changes, that is, in real-time. Otherwise a new value
is transmitted with the next cycle.
4.12.3
CAN connection
Follow these steps to run a device or sensor via the CAN interface (both the
reading and output of signals is possible):
1. Configuring the basic settings of the CAN connection (this section)
2. Creating the channel for CAN protocol: CAN protocol
3. Create one (or several) CAN bus channels
The CAN connection is displayed in the
. The CAN connection is available in the user-defined channel view
under the interface entry. The hardware channel view lists the CAN con-
nection directly below the device as long as the user has not already
moved the modules or channels.
Double-click a CAN entry or select
play the configuration dialogue. Set the baud rate and the length of the
identifier in the Main settings tab. We recommend giving a unique
name
, amending the
Main settings tab
Expert Logger Manual
Januar 2018
device to other Modbus users.
Application
enables the output value to be manually set via the
).
(for Channel settings only): The status of the input channel
: When this option is enabled the output value transmits
Description
Source
(of the signal).
Source Manual value
(
Channels
Properties
from the context menu to dis-
and, if necessary, entering a
195
Channel
) or select
ProfiSignal
applic-
Data type
(refer
tab with the CAN-symbol
Channel
Location
Delphin Technology AG
.