Table of Contents
Advertisement
Figure 3-16. Installing a replacement cooling module
24
PORTS
PORT
6
1
STATUS
GROUP
5
Firmly press the module completely into the slot to engage the connector on the
module with the connector in the chassis.
6
Using a number 2 Phillips screwdriver, carefully tighten the locking screws on the
cooling module. Do not overtighten.
Connecting cables to a Stinger MRT unit
Once the Stinger MRT is set up in the desired location, connect the unit to the local
subscriber lines or to its frame access point by attaching the appropriate cables to the
50-pin RJ-21 LINE connectors. For cable pinouts, see "Pinouts for subscriber line DSL
connections" on page C-4.
Stinger® MRT Getting Started Guide
Cooling module alignment slot
1
48
10
5
EXP2
EXP1
10BT
CONSOLE
Chassis alignment studs
Connecting cables to a Stinger MRT unit
25
PORTS
MAJOR
SHELF
ID
BITS
MINOR
ALARM
Installing a Stinger MRT
MRT
COOLING
SYSTEM STATUS
3-15
Advertisement
Table of Contents
