Imagroup Profile - Lucent Technologies Stinger MRT 19 Getting Started Manual

Table of Contents

Advertisement

The following steps show how verify the mode of the T1 or E1 trunk module, and
how to use this setting to change the type of line supported by it from T1, its default
mode, to E1.
1
Use the show command to verify the current mode of the trunk module. In the
following example, the system supports a T1 trunk module:
admin> show
Shelf 1 ( standalone ):
2
Change the Slot-Static-Config profile so that the module will support E1 lines.
For example:
admin> read slot-static {1 18 0}
SLOT-STATIC-CONFIG/{ shelf-1 trunk-module-2 0 } read
admin> list
[in SLOT-STATIC-CONFIG/{ shelf-1 trunk-module-2 0 }]
name = 1:18
physical-address* = { shelf-1 trunk-module-2 0 }
atm-parameters = { low-priority }
t1e1-trunk-card-mode = t1
admin> set t1e1-trunk-card-mode = e1
admin> write
LOG alert, Shelf 1, Controller, Time: 10:21:41--
trunk card mode changed from T1 to E1, atmtrunkreset 18 now ...
SLOT-STATIC-CONFIG/{ shelf-1 trunk-module-2 0 } written
3
Use the show command to verify that the trunk module configuration has
changed to support E1 lines.
admin> show
Shelf 1 ( standalone ):
Note
If the NVRAM command is used to clear the NVRAM of the Stinger MRT, the
t1e1-trunk-card-mode setting reverts to t1.

IMAgroup profile

The IMAgroup profile configures an inverse multiplexing over ATM (IMA) port.
When you enter the command new imagroup, a new profile is created to establish all
group-related IMA parameters. Following are the parameters of an IMAgroup profile
with sample settings:
[in IMAGROUP/test (new)]
name* = test
active = no
Stinger® MRT Getting Started Guide
{ shelf-1 slot-1 0 }
{ shelf-1 trunk-module-1 0 } UP
{ shelf-1 trunk-module-2 0 } UP
{ shelf-1 slot-1 0 }
{ shelf-1 trunk-module-1 0 } UP
{ shelf-1 trunk-module-2 0 } UP
Configuring T1 and E1 Trunk Modules
Reqd Oper
Slot Type
UP
RESET unknown
UP
oc3-atm-trunk-daughter-card
UP
ima-8t1-trunk-daughter-card
Reqd Oper
Slot Type
UP
RESET unknown
UP
oc3-atm-trunk-daughter-card
UP
ima-8e1-trunk-daughter-card

IMAgroup profile

9-15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Stinger mrt 23

Table of Contents